HP 72SR manual Angle exaggerated for clarity, Will use them later to pull the ink drain tubes

13.Bias the stand legs outward at the top, then tighten the screws firmly (see Fig. 1-2) but not all the way.

With your foot braced against the outside of the left caster support, gently tug the top of the stand leg toward you, while a second person tightens the screws. Repeat this pro- cess with the right stand leg. This step is required to ensure proper clearance for the media spools.

	Fig. 1-2. Bias the stand legs outward as shown
	(angle exaggerated for clarity)
Note	Leave the threading strings inside the stand legs. You
	will use them later to pull the ink drain tubes
	through the legs.

14.If purchased, install the VOC plenum kit.

Refer to the instructions included with the kit.

Unpacking and Assembly 1-9