HP 72SR manual Install the five reservoirs, Installing the reservoirs

29.Install the five reservoirs.

You may want to wear gloves during this procedure to pro- tect your hands from pigment ink stains.

◆Place the reservoir into the wire rack. Match the color or cleaning solvent label on the reservoir with the corre- sponding label on the printer.

◆Remove the packing material from the ink level floats inside the ink buckets.

◆Unscrew the plastic seal on the hook-shaped tube attached to the filter. Discard, or retain for subsequent use. A small amount of ink may come out of the tube (ink will be present in the tubes from factory testing).

◆Connect the hook-shaped tube to the reservoir’s draw tube, by pressing down until it seats with a click, and turning the screw-on connector 3/4 to 1 turn. See Fig. 1-7 below for location.

Note	Do not connect the hook-shaped tube to the air vent.
	Doing so will result in no ink being drawn from the
	reservoir.

◆Connect the float sensor cable from the reservoir to the data port on printer. See Fig. 1-7 below for location.

Fig. 1-7. Installing the reservoirs

Unpacking and Assembly 1-15