HP 72SR manual Load Media, Install and set up the RIP

Load Media

Send a Test Print from Server

When you empty a refill bottle into a reservoir, the green LED will blink until you install the corresponding profiler. Then the LED will turn off. Do not refill the inks until the green LED illuminates again.

3.After all four inks and the cleaning solvent reservoirs are full, press the Online/Offline key to display the Front Page screen.

4.From the Front Page screen, press the  (Menu) key to enter the menu system.

5.Press the ) key repeatedly to highlight Maintenance.

6.Press the  (Menu In) key to display the Maintenance menu.

7.Press the ) key repeatedly to highlight Fill Service Station.

8.Press the  (Menu In) key.

The solvent trough in the service station fills with solvent.

9.From the Maintenance Menu, press the ) key repeatedly to highlight Fill Heads With Ink.

10.Press the  (Menu In) key.

The printheads are filled with cleaning solvent, emptied, and filled with ink. This process takes approximately 30 minutes and is fully automated. During this process, occa- sionally check that the ink and cleaning fluid purged from the printheads is draining into the service station’s excess ink reservoir. If not, ensure that the drain tube is fully attached to the reservoir (see page 1-18).

To load media in the printer for the first time, see “Loading Roll- Fed Media” on page 3-14 for instructions. The printer ships with a starter roll of media and a cardboard takeup core pre-loaded on the spools.

1.Install and set up the RIP.

Refer to the Quick Start Guide for the ColorSpan print server, or the manual that accompanies the third party RIP you will be using.

2.Run the jet health routine to detect, recover, and replace unrecoverable jets.

See “Checking Jet Health” on page 3-6 for instructions.

3.Send a test print from the ColorSpan server or RIP to the printer, to verify your installation.

1-28 First-Time Power-Up and Test Print