HP 72SR manual Unloading Cutting Roll-Fed Media, Unloading and Cutting Roll-Fed Media

Unloading and

Cutting Roll-Fed

Media

1.Press the ) key on the Front Page screen to advance the printed portion of the media past the postheater.

2.On the Front Page screen of the control panel, press the Unload key.

3.The control panel prompts you to press ! to unload media, or ( to cancel.

4.Press ! to continue.

This detensions the supply and takeup spools.

5.Cut through the media with a utility knife along the cutting channel in the platen or below the postheater.

As you cut the media from the printer, hold it to prevent it from falling to the floor and possibly damaging it.

Note	If you scratch the platen while cutting media, be sure
	to buff them out with a fine grade of sandpaper.
	Scratches in the platen can cause media feed incon-
	sistencies, which can lead to head strikes and arti-
	facts in printed output.

6.Take the single print or the entire takeup spool with printed output to your finishing area, and re-load the takeup system.

◆To re-load the takeup, from the menu, press the Load key on the control panel.

Unloading and Cutting Roll-Fed Media 3-21