HP 72SR manual Unpacking and Assembly

21.Align center hole on each leg (between pins) with center hole in printer (see Fig. 1-5).

To speed this alignment, you can use a screwdriver inserted into the holes in the stand and printer.

Fig. 1-5. Stand alignment

22.Lower the printer chassis onto the stand.

23.Ensure that the printer lies flat on both of the stand brackets. Realign if necessary.

Note	The printer must lie flat on the stand brackets to
	avoid media feed problems during printer operation.

24.Attach the printer to the stand with one silver #3 screw in the center hole on each leg (see Fig. 1-5). Tighten all stand screws securely.

The silver screws provide a ground path between the printer engine module and the stand. Use an ohmmeter to verify a ground path between the silver electronics box and the sil- ver locating pin on the supply & takeup assembly, which is visible on the stand leg facing the spools. Resistance should be 5 ohms or less.

If the stand screws are not silver (in other words, “coated”), the wrong screws were installed. Replace the stand screws with the silver screws provided by MacDermid ColorSpan.

1-12 Unpacking and Assembly