NOTE: On the HUCB board, there is a remote RS232 connector. The remote RS232 system was used to connect to a modem on legacy systems. For sx2000 servers, modem support is removed, so connections to the remote RS232 connector are ignored.

Example B-8 DI Command

DL Command

DL - Disable LAN Access

Access level—Administrator

Scope—Complex

This command disables telnet LAN access. Disabling telnet access kills all of the current telnet connections and causes future telnet connection requests to be sent a connection refused message.

Example B-9 DL Command

Example:

In the following example, the administrator is connected by telnet to the MP. When DL runs, the telnet connection to the MP is closed.

MP:CM> dl

Disable telnet access and close open telnet connections? (Y/[N]) y WARNING: Answering yes will close this connection.

Are you sure? (Y/[N]) y

-> Telnet access disabled. All non-diagnostic connections closed. Connection closed by foreign host..

NOTE: The DL command is deprecated and does not appear in the help menu. Use the SA and DI commands to control both telnet and SSH connections.

EL Command

EL - Enable LAN Access

Access level—Administrator

Scope—Complex

This command enables telnet LAN access.

DL Command 155

Page 155
Image 155
HP Integrity Superdome and 9000 Superdome sx2000 manual DL Command, EL Command