HP Integrity Superdome and 9000 Superdome sx2000 Removing Protective Cardboard from the Housing

2.Remove the cardboard from the blower housing (Figure 3-13).

This cardboard protects the housing baffle during shipping. If it is not removed, the fans can not work properly.

Figure 3-13 Removing Protective Cardboard from the Housing

NOTE: Double-check that the protective cardboard has been removed.

3.Using the handles on the housing labeled Blower 3 Blower 2, align the edge of the housing over the edge at the top rear of the cabinet, and slide it into place until the connectors at the back of each housing are fully mated (Figure 3-14). Then tighten the thumbscrews at the front of the housing.

Figure 3-14 Installing the Rear Blower Housing

Setting Up the System 73