HP Integrity Superdome and 9000 Superdome sx2000 manual

1.Place the side bezel slightly above the blower housing frame.

Figure 3-19 Attaching the Side Bezels

2.Align the lower bezel tabs to the slots in the side panels.

3.Lower the bezel so the bezel top lip fits securely on the blower housing frame and the two lower tabs are fully inserted into the side panel slots.

IMPORTANT: Use four screws to attach the side skins to the top and bottom brackets, except for the top bracket on the right side (facing the front of the cabinet). Do not attach the rear screw on that bracket. Insert all screws but do not tighten until all side skins are aligned.

4.Using a T-10 driver, attach the screws to secure the side skins to the brackets.

5.Repeat step 1 through step 4 for the skins on the other side of the cabinet.

6.To secure the side bezels to the side skins, attach the blower bracket locks (HP part number A5201-00268) to the front and back blowers using a T-20 driver.

There are two blower bracket locks on the front blowers and two on the rear.

78 Installing the System