HP Integrity Superdome and 9000 Superdome sx2000 manual Installing the Front Blower Housing

4.Using the handles on the housing labeled Blower 0 Blower 1, align the edge of the housing over the edge at the top front of the cabinet, and slide it into place until the connectors at the back of each housing are fully mated (Figure 3-15). Then tighten the thumbscrews at the front of the housing.

Figure 3-15 Installing the Front Blower Housing

5.Unpack each of the four blowers.

6.Insert each of the four blowers into place in the blower housings with the thumbscrews at the bottom (Figure 3-16).

74 Installing the System