HP Integrity Superdome and 9000 Superdome sx2000 manual

cooling and electrical power. Table 2-15also lists the recommended breaker sizes for 4-wire and 5-wire sources.

WARNING! Do not connect a 380 to 415 V ac supply to a 4-wire PDCA. This is a safety hazard and results in damage to the product. Line-to-line or phase-to-phase voltage measured at 380 to 415 V ac must always be connected using a 5-wire PDCA.

Table 2-15 HP Integrity Superdome/sx2000 Dual-Core CPU Configurations1

Cells (in	Memory (DIMMs	I/O (fully	Typical Power	Cooling (BTU/Hr)	Breaker Power
cabinet)	per cell)	populated)	(Watts)		(Watts)2
8	32	4	9490	32382	11957
8	16	2	7620	26001	9601
8	8	4	8140	27776	10256
8	8	2	7180	24500	9047
8	4	4	7620	26001	9601
8	4	2	6660	22726	8391
6	16	4	7320	24978	9223
6	16	2	6360	21702	8013
6	8	4	7000	23886	8820
6	8	2	6040	20610	7610
6	4	4	6680	22794	8417
6	4	2	5720	19518	7207
4	16	4	6170	21054	7774
4	16	2	5210	17778	6564
4	8	4	5960	20337	7509
4	8	2	5000	17061	6300
4	4	4	5760	19655	7257
4	4	2	4800	16379	6048
2	16	2	4010	13683	5052
2	8	2	3890	13274	4901
2	4	2	3780	12898	4763

1Values in Table 2-15are based on 25 W load I/O cards, 1 GB DIMMs and four Intel® Itanium ® dual-core processors

with 18 MB or 24 MB cache per cell board or four PA-RISC processors with 64 MB.

2These numbers are valid only for the specific configurations shown. Any upgrades can require a change to the breaker size. A 5-wire source uses a 4-pole breaker, and a 4-wire source uses a 3-pole breaker. The protective earth (PE) ground wire is not switched.

Table 2-16 HP Integrity Superdome/sx2000 Single-Core CPU Configurations1

Cell (in cabinet)	Memory (DIMMs	I/O (fully	Typical Power	Cooling (BTU/Hr)	Breaker Power
	per Cell)	populated)	(Watts)		(Watts)2
8	32	4	9130	31181	11503
8	16	2	7260	24794	9147
8	8	4	7783	26580	9806

Environmental Requirements 55