HP Integrity Superdome and 9000 Superdome sx2000 List of Figures, Backplane Rear View Cell Board

List of Figures

1-1	Superdome History	17
1-2	Superdome Cabinet Components	19
1-3	UGUY	23
1-4	Management Processor	25
1-5	HUCB	26
1-6	HSO and RCS Locations	29
1-7	Backplane Power Supply Module	30
1-8	Backplane (Rear View)	30
1-9	Cell Board	31
1-10	Cell Memory	33
1-11	PCI-X I/O Rope Mapping	39
1-12	PCIe I/O Rope Mapping	41
1-13	e-Link Cable	43
1-14	Backplane Cables	44
1-15	Itanium Firmware Interfaces	45
1-16	PA-RISC Firmware Interfaces	47
2-1	PDCA Locations	52
2-2	Airflow Diagram	57
3-1	Normal Tilt Indicator	61
3-2	Abnormal Tilt Indicator	62
3-3	Front of Cabinet Container	64
3-4	Cutting the Polystrap Bands	64
3-5	Removing the Ramps from the Pallet	65
3-6	Power Supply Mounting Screws Location	66
3-7	I/O Chassis Mounting Screws	66
3-8	Shipping Strap Location	68
3-9	Removing the Mounting Brackets	69
3-10	Positioning the Ramps	70
3-11	Rolling the Cabinet Down the Ramp	70
3-12	Blower Housing Frame	72
3-13	Removing Protective Cardboard from the Housing	73
3-14	Installing the Rear Blower Housing	73
3-15	Installing the Front Blower Housing	74
3-16	Installing the Blowers	75
3-17	Attaching the Rear Side Skin	76
3-18	Attaching the Front Side Skins	77
3-19	Attaching the Side Bezels	78
3-20	Attaching the Leveling Feet	79
3-21	Installing the Lower Front Door Assembly	80
3-22	Installing the Upper Front Door Assembly	81
3-23	Installing the Rear Blower Bezel	82
3-24	Installing the Front Blower Bezel	83
3-25	PDCA Assembly for Options 6 and 7	85
3-26	A 4-Wire Connector	85
3-27	A 5-Wire Connector	86
3-28	Installing the PDCA	86
3-29	Checking PDCA Test Points (5-Wire)	87
3-30	Wall Receptacle Pinouts	88
3-31	Power Supply Indicator LED	89
3-32	Removing Front EMI Panel Screw	90
3-33	Removing the Back EMI Panel	90
3-34	Cable Labeling	91

8List of Figures