HP Integrity Superdome and 9000 Superdome sx2000 manual Unpacking the Pdca, Returning Equipment

Unpacking the PDCA

At least one PDCA ships with the system. In some cases, the customer might order two PDCAs, the second to be used as a backup power source. Unpack the PDCA and ensure it has the power cord option for installation.

Several power cord options are available for the PDCAs. Only options 6 and 7 are currently available in new system configurations (Table 3-1 (page 71)). Table 3-2 (page 71) details options 6 and 7.

Table 3-1 Available Power Options

Option	Source	Source Voltage	PDCA	Input Current Per
	Type	(Nominal)	Required	Phase 200 to 240 V
				ac1
6	3-phase	Voltage range 200 to	4-wire	44 A maximum per
		240 V ac,		phase
		phase-to-phase, 50 Hz
		/ 60 Hz
7	3-phase	Voltage range 200 to	5-wire	24 A maximum per
		240 V ac,		phase
		phase-to-neutral, 50 Hz
		/ 60 Hz

1A dedicated branch circuit is required for each PDCA installed.

Power Receptacle Required

Connector and plug provided with a 2.5 m (8.2 feet) power cable. An electrician must hardwire receptacle to 60 A site power.

Connector and plug provided with a 2.5 m (8.2 feet) power cable. An electrician must hardwire receptacle to 32 A site power.

Table 3-2 Power Cord Option 6 and 7 Details

PDCA Part Number	Attached Power Cord	Attached Plug	Receptacle Required
A5201-69023 (Option	OLFLEX 190 (PN 600804) is a 2.5 meter	Mennekes ME 460P9	Mennekes ME 460R9 (60
6)	multiconductor, 600 V, 90˚C, UL and CSA	(60 A capacity)	A capacity)
	approved, oil resistant flexible cable. (8
	AWG 60 A capacity)
A5201-69024 (Option	H07RN-F (OLFLEX PN 1600130) is a 2.5	Mennekes ME	Mennekes ME
7)	meter heavy-duty neoprene jacketed	532P6-14 (32 A	532R6-1500 (32 A
	harmonized European flexible cable. (4	capacity)	capacity)
	mm2 32 A capacity)

Returning Equipment

If the equipment is damaged, use the original packing material to repackage the cabinet for shipment. If the packing material is not available, contact the local HP Sales and Support Office regarding shipment.

Before shipping, place a tag on the container or equipment to identify the owner and the service to be performed. Include the equipment model number and the full serial number, if applicable. The model number and the full serial number are printed on the system information labels located at the bottom front of the cabinet.

WARNING! Do not attempt to push the loaded cabinet up the ramp onto the pallet. Three people are required to push the cabinet up the ramp and position it on the pallet. Inspect the condition of the loading and unloading ramp before use.

Repackaging

To repackage the cabinet, follow these steps:

1.Assemble the HP packing materials that came with the cabinet.

2.Carefully roll the cabinet up the ramp.

3.Attach the pallet mounting brackets to the pallet and the cabinet.

Unpacking and Inspecting the System 71