HP Integrity Superdome and 9000 Superdome sx2000 manual 27 a 5-Wire Connector

Figure 3-27 A 5-Wire Connector

To install the PDCA, follow these steps:

WARNING! Make sure the circuit breaker on the PDCA is OFF.

1.Remove the rear PDCA bezel by removing the four retaining screws.

2.Run the power cord down through the appropriate opening in the floor tile.

3.Insert the PDCA into its slot (Figure 3-28 (page 86)).

Figure 3-28 Installing the PDCA

4.Using a T-20 driver, attach the four screws that hold the PDCA in place.

5.If required, repeat step 2 through step 4 for the second PDCA.

86 Installing the System