7.9 Configuration for Extreme switches

The configuration in Example 7-42is from one of a pair of Extreme switches which we tested in place of the Cisco Core switches. The Extreme switches had a subset of the functionality of the GbESM switch modules, so our testing was limited. We were able to successfully test the following:

￿VLAN tagging using 802.1Q

￿Link aggregation (trunking) with static trunks; the Extreme switch did not support LACP.

￿RIP

Testing of the different variations of Spanning Tree Protocol was only partially successful. This is due to some limitations of the Extreme switch’s functionality as well as certain proprietary enhancements to the standards which the GbESM did not support. We were able to configure OSPF but not test it because an additional license which we did not have was required to enable this function.

Note that certain default configuration text was removed from the below due to extreme length. This test was present when we reset the switch to its factory defaults.

Example 7-42 Extreme switch configuration

# Full Detail Configuration

#

#Summit400-48t Configuration generated Tue Jun 14 05:33:14 2005

#Software Version 7.2e.1 (Build 10) [non-ssh] by Release_Master on 03/26/04 18:29:56

configure sys-recovery-level none enable system-watchdog

configure reboot-loop-protection threshold 0 configure vlan default delete ports all create vlan "VLAN10"

create vlan "VLAN20" create vlan "VLAN99"

#

# Config information for VLAN Default.

configure

vlan

"Default" tag 1

#

VLAN-ID=0x1 Global Tag 1

configure

stpd

s0 add vlan "Default"

 

configure vlan "Default" qosprofile "QP1"

configure vlan "Default" ipaddress 9.42.171.98 255.255.255.0 configure vlan "Default" add port 1 untagged

configure vlan "Default" add port 3 untagged configure vlan "Default" add port 4 untagged configure vlan "Default" add port 5 untagged configure vlan "Default" add port 6 untagged configure vlan "Default" add port 7 untagged configure vlan "Default" add port 8 untagged configure vlan "Default" add port 9 untagged configure vlan "Default" add port 10 untagged configure vlan "Default" add port 11 untagged

#similar lines for ports 13-50 omitted

#Config information for VLAN Mgmt.

#No IP address is configured for VLAN Mgmt.

#Config information for VLAN VLAN10.

configure vlan

"VLAN10" tag 10

# VLAN-ID=0xa Global Tag 4

configure

stpd

s0 add vlan "VLAN10"

 

configure

vlan

"VLAN10" qosprofile

"QP1"

Chapter 7. Nortel Networks L2/3 GbESM configuration and network integration 143

Page 157
Image 157
IBM L2/3 manual Configuration for Extreme switches, Example 7-42 Extreme switch configuration