
1. If you have not already done so, remove the front covers as described in “Removing the Front Covers Only” on page
2.If you are installing drives in bank D or E for the first time, you must install a additional backplane before you can install drives. See “Installing a SSA
Backplane in Bank D, or E” on page
3. Each | drive | you | plan | to | install | in | bank C, D, | or | E | must have | the |
| ||||||||||||||
disk | drive | carrier attached. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||||
Note: | SSA | disk | drives | carriers | have | a | black | plastic | bezel | around | the status |
| ||||||||||||||
lights of the carrier. SCSI disk carriers have a | white | bezel. |
|
|
|
|
| |||||||||||||||||||
Attention: | Handle the | disk | drive | with care as it is very fragile and can be easily | ||||||||||||||||||||||
damaged | if | exposed | to | shock, | electrostatic | discharge, | or | rough | handling. |
|
| |||||||||||||||
4. A | minimum | of | two | SSA | disk | drives are | required | when | populating | individual | banks |
| ||||||||||||||
C, | D, | or | E. They must be located | in | bays | 1 | and | 5 | prior | to | installing | additional | ||||||||||||||
disk drives in the next unused position of | banks C, |
| D, | or | E. |
|
|
|
|
|
| |||||||||||||||
Attention: | SSA | backplanes | must | be | fully populated. Each backplane connector |
|
|
| ||||||||||||||||||
must | have a | disk | drive | or | a | blank | carrier | installed | at | all | times. | If | you | are | insta | |||||||||||
a disk drive in a bay that | was | not | previously | utilized, | you | must | remove | the | blank | |||||||||||||||||
carrier | prior | to | installing | the | disk drive. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
a. Rotate the carrier latch to the open position.
b. Position | the | drive carrier assembly vertically, with the connector facing the |
rear of | the | server. |