4.When a message indicates the system is in maintenancediag mode, enter the command.

Note: It may be necessaryTERM to typeset again.

5. When DIAGNOSTIC OPERATING INSTRUCTIONS is displayed, follow the displayed instructions to checkout the desired resources.

6.When testing is complete; use the F3 key to return to DIAGNOSTIC OPERATING INSTRUCTIONS. Then press the F3 key again to return to the AIX operating system prompt.

7.Press Ctrl-D to log offroot orfromsuperuser.

Standalone Diagnostic Operation

Standalone Diagnostics provide a method to test the system when the Online

Diagnostics are not installed and a method of testing the disk drives that cannot be tested by the Online Diagnostics.

No Error Log Analysis is done by the Standalone Diagnostics.

The CD-ROM drive and the SCSI controller that controls it cannot be tested by the Standalone Diagnostics.

Running the Standalone Diagnostics

To run Standalone Diagnostics in service mode, take the following steps:

1. Verify

with the system administrator and

system

users

that the system unit may

be

shut

down, then

stop all

programs including the AIX operating system. (Refer

to

the

AIX

operating

system

documentation

shutdown

command

information.)

2.

Remove

all

tapes,

diskettes,

and

CD-ROMs.

 

 

 

3.

Insert

the

Diagnostic

CD-ROM

into

the CD-ROM drive.

 

4. Turn off the system unit.

5.Turn the power on.

a.When or after the diskette indicator appears, press F5 on the direct attached keyboard or 5 on the tty keyboard to indicate that diagnostics are to be loaded.

b.Enter any requested passwords.

c. Follow any instructions to select a console.

6.After the diagnostic controller loads, DIAGNOSTIC OPERATING INSTRUCTIONS appear on the console display.

6-12IBM RS/6000 7025 F50 Series User's Guide

Page 258
Image 258
IBM RS/6000 7025 manual Standalone Diagnostic Operation, Running the Standalone Diagnostics