
Removing a Disk Drive, Tape Drive, or
Note: To locate bay A or bay B, see the illustration given on page
To remove a drive from bay A or bay B, do the following steps:
1. If | you | have | not | already done | so, remove the covers as described in “Removing |
Both | the | Front | and | Side Covers” | on page |
2. Locate the drive you want to remove.
3. Slide the drive halfway out of the front of the bay.
4. Disconnect the cables from the back of the drive.
5. Remove | the drive | from | the | bay. Store | the | drive in a safe place. |
|
| ||||||||
6. | Go | to | Table | page | and update | the | drive information; | then | return | here |
| |||||
| to | determine | your | next step. |
|
|
|
|
|
|
|
| ||||
7. | If | you | are | removing | another | internal drive | from | bay A or bay B, | return | to | step 2 | |||||
8. | If | you | are | installing | another | internal | drive | in | bay A or bay B, | go to | step | “Instal | ||||
| a Disk | Drive, | Tape | Drive, | or | Bay | A or | Bay B” on | page |
|
|
9. If you have other procedures to perform, refer to “Option List” on page
10.If you do not have any other procedures to perform, replace the covers as described in “Replacing Both the Front and Side Covers” on page