Step 3. Running System Verification

The Diagnostic Operating Instructions should be displayed.

1.Press the Enter key.

2.If the terminal type has not been defined,Initializeyou must use the

Terminal option on the Function Selection menu to initialize the operating system environment before you can continue with the diagnostics.

3.If you want to do a general checkout without much operator action, Select t Diagnostic Routines option on the Function Selection menu.

If you want to do a more complete

checkout

including

the use

of

wrap

plugs,

select

Advancedthe

Diagnostics

option

on

the Function

Selection menu. The

 

 

advanced diagnostics are primarily

for the service

representative;

they

may

instruct

you

to install

wrap plugs

to

better

isolate

a

problem.

 

 

 

4. Select

Systemthe

Verification

option

on

the

Diagnostic Mode

Selection

menu.

 

 

5.If you want to run a general checkout of all installedAll resources, Select the Resource option on the Diagnostic Selection menu.

If you want to check one particular resource, select that resource on the Diagnostic Selection menu.

6. Go to Step 4.

Step 4. Additional System Verification

The checkout programs end with either the Testing Complete menu and a message statingNo trouble was found or the A Problem Was Detected On (Time Stamp)

menu with an SRN.

1. Press Enter to return to the Diagnostic Selection menu.

2.If you want to check other resources, select the resource. When you have checked all of the resources you need to check, go to Step 5.

Chapter 8. Using the System Verification8-3Procedure

Page 299
Image 299
IBM RS/6000 7025 manual Running System Verification, Additional System Verification