
Step 11
1. If the terminal type has not been defined,Initializeyou must use the
Terminal option on the Function Selection menu to initialize the operating system environment before you can continue with the diagnostics. This is a separate and different operation than selecting the console display.
2.SelectDiagnostic Routines.
3.Press the Enter key.
4.In the following table, find the menu or system response you received when you selectedDiagnostics. Follow the instructions given in the Action column.
System Response | Action |
|
The Diagnostic Mode Selection menu is | Select Problem Determination and go to “Step | |
displayed. | 12.” |
The Missing Resource menu is displayed.Follow the displayed instructions until either the Diagnostic Mode Selection menu or an SRN is displayed.
If the Diagnostic Mode Selection menu is displayed, select Problem Determination and go to “Step 12.”
If you get an SRN, record it, and go to “Step 14.”
The New Resource menu is displayed. Follow the displayed instructions.
Note: | Devices | attached | to | serial | ports S1 or |
S2 | will not | appear | on | the New | Resource |
menu. Also, ISA adapters do not appear | |||||
unless they have been identified and | |||||
configured. |
|
|
|
If the Diagnostic Mode Selection menu is displayed, select Problem Determination and go to “Step 12.”
If you get an SRN, record it, and go to “Step 14.”
If you do not get an SRN, go to “Step 17.”
The system does not respond to selectingGo to “Step 10.”
diagnostics