
With the remote terminal connected to serial port primary1 and defined as the console device, there are two tests you can perform:
1.Will the modemdrop the connection after the "System initialization complete" message appears at the remote terminal?
If yes, this is the correct response. The modem is set up correctly.
If | no, | try | another | &Dn | setting | for | your server's modem. See your modem manual | |||||||||||||
for | this |
| information. The | &Dn | command | appears | in | three | places | each | in | three | of | |||||||
the | sample |
| modem |
|
|
| 2 | files |
|
|
|
|
|
|
|
|
| |||
| configuration. |
|
|
|
|
|
|
|
|
| ||||||||||
2. Will | the | server's disconnectmodem | when | the | power drops? You can make this |
|
|
| ||||||||||||
observation | at | the |
| remote terminal by commanding | your | server | to shutdown and |
| ||||||||||||
power off. | (The AIX commandshutdown | will | do this.) | Watch | for the | message |
|
| ||||||||||||
NO CARRIER |
| on | your |
| remote | terminal. |
|
|
|
|
|
|
|
|
| |||||
If | yes, | this | is | the correct | response. The | modem is | set | up | correctly. |
| ||||||||||
If | no, | try | another | &Dn | setting | for | your server's modem. See your model manual | |||||||||||||
for | this |
| information. The | &Dn | command | appears | in | three | places | each | in | three | of | |||||||
the | sample |
| modem |
|
|
| 2 | files |
|
|
|
|
|
|
|
|
| |||
| configuration. |
|
|
|
|
|
|
|
|
|
Recovery Strategy
The | recovery | strategy consiststwoof callsmakingto establish a remote session. | |
This | is the | easiest | solution to implement, and allows more freedom for configuring |
your | server's | serial | ports. |
To set up a remote terminal session, dial into the Service Processor and start th system. After the operating system is loaded and initialized, the connection will dropped. At this point, you call the server back and the operating system will a and offer you the login prompt.
2 Only the following sample modem configuration files contain the &Dn command (in three places each):
Ÿ modem_f.cfg Ÿ modem_f0.cfg Ÿ modem_f1.cfg
If you are using modem_z.cfg or modem_z0.cfg, you | cannot control DTR response. If | your | remote |
terminal does not disconnect after logging off, you | must command the remote terminal | emulator | to hang |
up. This then breaks the connection. |
|
|
|
Appendix | D. Modem |
|
|