Intel MB440LX manual Removing a 5.25-inch Peripheral Device, 111

Removing a 5.25-inch Peripheral Device

See Figures 4-15, 4-16, 4-17, and 4-18.

1.Observe the warnings and cautions on page 3, “Safety Guidelines.”

2.Remove both side covers and the top cover (page 80).

3.Remove the snap-in plastic peripheral bay cover (page 86), and place it on a smooth surface so that it doesn’t get scratched.

4.Disconnect the power cable and the signal cable from the drive.

5.While squeezing the protruding plastic snap-in rails attached to the drive toward each other, carefully slide the drive forward out of the bay, and place it on an antistatic surface.

6.Remove and save the four screws and the two snap-in slide rails from the device.

7.If you leave the bay empty, install a stainless steel EMI shield on the bay and a filler panel on the snap-in plastic peripheral bay cover for proper cooling and airflow.

8.Replace the snap-in plastic peripheral bay cover.

9.Replace the top cover and both side covers.

10.If you leave the bay empty, run the SCU to reconfigure the system. For information about running this utility, see Chapter 3, “Configuring The System.”

M440LX Server System Product Guide 111