Board Set

The system board supports two processor modules, a memory module, and an RPX module.

! CAUTION

The Pentium II processor is be extremely sensitive to ESD and always requires careful handling. After removing the module from its protective wrapper or from the system board, place it heat sink side down on a nonconductive, static-free surface. Do not slide the module over any surface.

If you are upgrading a one-processor system with a second processor, you must install a voltage regulator and remove the termination board from the CPU1 slot.

Removing the Termination Board

See Figure 4-5.

1.Observe the warnings and cautions on page 3, “Safety Guidelines.”

2.Remove the left side cover (page 80).

3.Press the latches on the Terminator Latching Assembly (TLA) inward.

4.Pull the TLA out of the module retention bracket.

5.Holding the terminator board by its top edge, carefully rock it back and forth until the edge connector pulls free.

88

Chapter 4 Working Inside Your System

Page 88
Image 88
Intel MB440LX manual Board Set, Removing the Termination Board