Intel MB440LX manual Removing the Snap-in Plastic Peripheral Bay Cover

Removing the Snap-in Plastic Peripheral Bay Cover

See Figure 4-4.

1.Observe the warnings and cautions on page 3, “Safety Guidelines.”

2.Remove the right side cover (when viewed from the front, see page 80).

3.To remove the snap-in plastic peripheral bay cover, push up on the bottom flexible tab below the 3.5-inch diskette drive. Then push the tab toward the front of the system until you can grasp the lower right corner of the cover.

▲! CAUTION

Do not try to remove the snap-in peripheral bay cover by inserting a screwdriver or other tool in the notch on the left side of the cover. The cover may break.

4.Pull the lower right corner of the cover toward you with an upward twisting motion to disengage the top flexible tab.

5.Remove the snap-in peripheral bay cover from the system, and place it on a flat surface.

OM05778

Figure 4-4. Snap-in Plastic Peripheral Bay Cover

86 Chapter 4 Working Inside Your System