JVC VR-509E instruction manual Part Names and Functions Signal I/O Terminals

Getting Started

Part Names and Functions (Signal I/O Terminals)

WARNING: SHOCK HAZARD

-DO NOT OPEN

AVIS:RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

AC IN 220V - 240V 50Hz/60Hz

1	2	3	5	7		9
			4	6	8		10

12

11

1 [ALARM IN 1 to 9] Terminals 1 - 9 7 [WARNING OUT] Terminal

ALARM REC is activated when signals are input to these terminals. (Page 33)

Outputs a signal when an operation abnormality or other error occurs on the hard disk. (Page 96)

2[EMERGENCY] Terminals

EMERGENCY REC is activated when signals are input to these terminals. (Page 33)

3[CLOCK RST IN] Terminal

The terminal for resetting the time. The VR-509 clock is reset when signals are input. (Page 19)

4[CLOCK RST OUT] Terminal

The clock reset signal is output in accordance with the following timing:

• When the VR-509 internal clock is 00:00 or 12:00.

5[ALARM RESET] Terminal

Recording is stopped when this signal is input in the ALARM REC mode.

6[REC OUT] Terminal

Outputs the recording status of the VR-509. (Page 29)

8[EXT REC IN] Terminal

Activates recording with an external signal. (Page 29)

9[OPE ON/OFF] Terminal

Switches between OPE ON or OFF when the signal is input. (Page 16)

10[SPOT 1· 2] Terminal

The input signal selects the image to be output with SPOT OUTPUT. (Page 26)

11[COMMON] Terminal

The common grounding terminal. Connected to the signal grounding terminal on the device connected.

12[SIGNAL GND] Terminal

The common grounding terminal. Connected to the signal grounding terminal on the device connected.

(This can be used when there are insufficient common grounding terminals.)

*Do not use this terminal for protective earthing.

13