JVC VR-509E instruction manual Setting up the Motion Detect Area SET, Motion Detection Check Mode

Setting up the MOTION DETECT AREA SET

Sets up the area for motion detection. This setting is applicable for when both [USER] and any other parameter has been selected for the sensitivity level.

1.Press the [MENU] button.

•The [MENU] → [REC DETAIL] → [ALARM REC] screens will be displayed in this sequence in accordance with the [MENU Screen Operations] explained on page 17.

Recording Camera Images

Motion Detection Check Mode

The Motion Detection Check screen will be displayed when [SET] is pressed on the [MOTION DETECT AREA SET] screen.

Motion Detection Check screen

ALARM REC
CAM NO		1	2.
DURATION		3MIN
PREALARM REC		10SEC
MOTION DETECT SET		8
DYNAMIC SENSITIVITY LEVEL (DEFAULT-8)
STOP LEVEL	(DEFAULT-2)	2
TARGET AREA LEVEL	(DEFAULT-2)	2	3.
MOTION DETECT AREA SET ..

CAMERA : 01

SCENE : NORM

SENS LEV : 08

STOP LEV : 02

AREA LEV : 02

„Press the [–/+] keys to select the scene.

Enabled motion detection area

Motion detection check mode display (scene and parameter levels.)

*Red characters cannot be amended. motion detection mode

2.Select the camera input that is to be set up with [W/X].

3.Select [MOTION DETECT AREA SET] with the [S/T] keys, and then press [SET].

•The [MOTION DETECT AREA SET] screen will be displayed. The screen will be divided by 16 x 12 to make a total of 192 areas. Each of these areas can then be enabled or disabled.

The current enabled area will be displayed in blue.

* The cursor is

4. located at the top left-hand area when shipped from the factory.

4.Select the desired area with the [S/T/W/X] keys, and then switch between Enabled/Disabled with [–/+].

•Press [+] to enable the area and display it in blue. Press [–] to disable the area.

•Press [+] while holding down the [FUNCTION] key to enable all areas. Press [–] while holding down the [FUNCTION] key to disable all areas.

5.Press the [SET] button.

•A confirmation screen will be displayed if the motion detection area has been changed with procedure #4. In this event, proceed to procedure #6.

•A motion detection check screen will be displayed if the motion detection areas have not been amended. (See Motion Detection Check Mode on page 37)

6.Select [SAVE] on confirmation screen with the [W/X] keys, and then press the [SET] button.

•This completes the motion detection area registration

procedure.

„Press the [RETURN] button to return to the previous screen.

1.Press the [SET] button to check motion detection. The color of the circle at the top left-hand side of the check screen is set in accordance with the following conditions: Red: Motion detection enabled

Gray: Motion detection disabled

2.Press the [RETURN] button to return to the [Motion Detection Check] screen.

*If motion detection fails, press the [–/+] keys on the [Motion Detection Check] screen, amend the scene for

the motion detection mode, and then perform the check once again.

„Press the [RETURN] button to return to the previous screen.

*Check to ensure that a setting that allows motion detection to be carried out is set for the [Motion Detection Set (Scene and Level Set)] parameters.

(See M.DET on page 31)

(See Motion Detection with Freely Determined Sensitivity Levels on page 36)

CAUTION

Motion detection is not possible if the number of motion detection areas is less than the Detection Area Count set for the Target Area Level in Table #2 of page 35.

37