RS-232C Interface

3. Details of the Commands (continued)

3.5.Other Commands

Data “0” to “9” (30H to 39H) [BASIC/JVC-1] Used for numeral input.

ENTER (40H) [BASIC/JVC-1]

This command is used as the input end mark when the transmission of all numerical commands has been completed.

CLEAR ERROR (41H) [BASIC/JVC-1]

Clears only the last numerical command entered (transmitted.) Also clears the error status.

CLEAR (56H) [BASIC/JVC-1]

Clears the current mode, and clears the error status. The system is ready to receive new commands after this command has been received.

ACTIVE SENSE (DFH) [JVC-1]

Returns the ACK response. (This is the command to check that the connected equipment is operating normally.)

JVC TABLE 1 ON (F6H) [BASIC/JVC-1]

The command to activate the JVC TABLE 1. JVC TABLE 1 is maintained until F7H is output once this has been set.

BASIC TABLE ON (F7H) [BASIC/JVC-1]

The command to set the BASIC TABLE to ON.

REC/DUB REQUEST (FAH) [BASIC/JVC-1]

This command must be sent before the REC command is transmitted.

VTR/HDR INQ (FBH) [BASIC/JVC-1]

Returns the ACK response. (This is the command to check that the connected equipment is the VR-509E.)

CAUTION

The only method of clearing the warning mode when an error occurs with the VR-509E is to switch the power supply OFF and then ON again.

123

Page 123
Image 123
JVC VR-509E instruction manual Other Commands