HP 30 30 manual DRV-13 Motor Direction Set 7-Segment Keypad, 130, DRV-16 Hz/Rpm Display

Chapter 6 - Parameter Description [DRV]

Output Phase Loss	Phase Open	PO
Inverter Over-Load	Inv. OLT	IOLT

☞Note: There are WDOG error, EEP error, and ADC Offset for the inverter Hardware Fault - the inverter will not reset when H/W fault occurs. Repair the fault before turning on the power.

☞Note: Only the highest-level fault will be displayed when multiple faults occur.

Related Functions: FU2-01 to FU2-05 [Previous Fault History] FU2-06 [Erase Fault History]

FU2-01 to FU2-05: There are up to 5 faults saved.

FU2-06: Erases the faults saved in FU2-01 to FU2-05.

DRV-13: Motor Direction Set (7-Segment Keypad)

130

Factory Default: 0

This code sets the motor direction when using the 7- Segment keypad.

7-Segment Display	Description
0	Run to forward direction
1	Run to reverse direction

DRV-14: Command/Output Frequency Display (LCD Keypad)

DRV►TAR 0.00Hz

14 OUT 0.00Hz

Factory Default: 0.00Hz

This code shows the Command (Target) Frequency set in DRV00 and inverter Output Frequency.

DRV-15: Reference/Feedback Frequency Display (LCD Keypad)

DRV►REF 0.00Hz

15 FBK 0.00Hz

Factory Default: 0.00Hz

This code shows the Reference Frequency and Feedback Frequency while PID operation.

This code appears only when ‘PID’ is selected in FU2-47.

DRV-16: Hz/Rpm Display

DRV►	Fault		12	nOn
12	None
Factory Default:		None		nOn

Set this parameter to 0 [Hz] to display frequency, or to 1[Rpm] to display speed Ralated code

Related Functions: Changing the Hz/Rpm display affects the following parameter display.

DRV-00, 05, 06, 07, 14 FU1-20, 21,22, 24, 25, 32 FU2-32

I/O-03, 05, 08, 10, 20, 21, 22, 23, 24, 42, 43 EXT-08, 10

DRV-20: FU1 Group Selection (7-Segment keypad)

DRV-21: FU2 Group Selection (7-Segment keypad)

DRV-22: I/O Group Selection (7-Segment keypad)

DRV-23: EXT Group Selection (7-Segment keypad)

DRV-24: COM Group Selection (7-Segment keypad)

DRV-25: APP Group Selection (7-Segment keypad)

Select the desired group and press the PROG/ENT key to move into the desired group. The parameter in the group can be read and written after moving into the desired group.

6-7