HP 30 30 Application Group APP APP-00 Jump to desired code #, APP-01 Application Mode Selection

Chapter 6 - Parameter Description [APP]

6.6Application Group [APP] APP-00: Jump to desired code #

APP► Jump code

001

Factory Default: 1

Jumping directly to any parameter code can be accomplished by entering the desired code number. This code is available only with LCD keypad.

APP-01: Application Mode Selection

APP► App. mode					01	0
01		None
Factory Default:			None			0
	This code sets the application mode.
	Setting Range				Description
	LCD	7-Seg
	None	0		Application mode is not selected.
	Traverse			Traverse mode is selected in application
		1		group. Related functions (APP-02~07) are
				displayed.
	MMC			MMC (Multi-Motor Control) mode is
		2		selected in application group. Related
				functions (APP-08~31) are displayed.
	DRAW			DRAW mode is selected in application
		3		group. Related functions (APP-32~33) are
				displayed.

[Traverse]: This is a mechanism to wind thread to an intended shape on a reel with a rotary motion and reciprocation. Adjusting the speed of mechanical reciprocation can make different shapes of thread reel. The following figure shows an example. The guide should move with low speed at the center of the reel and fast at the edge of the reel.

Related Functions: APP-02 to APP-07 [Traverse Parameters] I/O-12 to I/O-14 [Multi-Function Input] EXT-30 to EXT-32 [Multi-Function Output]

Thread
Traverse			Traverse			Thread
Rotary			Reciprocation			(Constant
Motion			(Mechanical)			Speed)
	[An example of Traverse Operation]
		APP-03
APP-02		Trv. Scr
Trv. Amp				APP-06
				Offset-High
						Reference
						Speed
					APP-07
					Offset-Low

APP-04	APP-05
Traverse Acc	Traverse Dec

[Traverse Operation Pattern]

[MMC]: The ‘PID’ control should be selected in FU2-47 to use this function.

♦One inverter can control multiple motors. This function is often used when controlling the amount and pressure of flow in fans or pumps. Built-in PI controller controls a main motor after receiving process control value and keeps the control value constant by connecting auxiliary motors to commercial line when needed.

♦In case that flow amount or flow pressure is beyond or below the reference so the main drive cannot control by itself, auxiliary motors are automatically turned on/off. Maximum four (Q1~3 and Aux. output) auxiliary motors can be run. Each Starting and Stop Frequency should be set to four auxiliary motors.

♦Auto Change can be selected to automatically switch the order of the running motors for keeping motor run-time constant. Set mode ‘1’ for automatic changing of auxiliary motors only and set mode ‘2’ for automatic changing of all

6-62