HP 30 30 manual EXT-05 V2 Mode Selection Sub-A, Sub-C, EXT-06 ~ EXT-10 Analog Voltage Input

Chapter 6 - Parameter Description [EXT]

	Setting Range				Description		This is the filtering time constant for ‘V2’ signal input. If the
	LCD		7-Seg				‘V2’ signal is affected by noise causing unstable operation
	Interlock3		31
							of the inverter, increase this value. Increasing this value
	Interlock4		32
							may make response time slower.
	Pre excite		33	Pre-excitation
	Spd/Trq		34	Sensored Vector_SPD/TRQ
							EXT►	V2 volt x1
				Operation change						07	0.00
	ASR P/PI		35	Sensored Vectro_SPD			07		0.00 V
				P/PI control selection
							Factory Default:		0.00 V		0.00
							This is the minimum voltage of the ‘V2’ input at which the
	EXT-05: V2 Mode Selection – Sub-A, Sub-C						inverter outputs minimum frequency.
EXT► V2 mode					05	0	EXT► V2 volt y1			08	0.00
05		None					08		0.00 Hz
Factory Default:			None			0	Factory Default:		0.00 Hz		0.00
	‘V2’ signal can be used as the frequency reference and						This is the minimum frequency the inverter outputs when
	override function.						there is the minimum voltage (EXT-07) on the ‘V2’ terminal.
	[None]						EXT► V2 volt x2			09	10.00
	V2 signal is not used.						09		0.00 V
	[Override]						Factory Default:		10.00 V		10.00
	‘V2’ signal override the frequency reference signal (V1, I,						This is the maximum voltage of the ‘V2’ input at which the
	V1+I) selected in DRV-04.						inverter outputs maximum frequency.
	[Reference]						EXT► V2 volt y2			10	60.00
	‘V2’ signal is used as the frequency reference. At this time,						10	60.00 Hz
	the frequency reference selected in DRV-04 is ignored.
							Factory Default:		60.00 Hz		60.00
							This is the maximum frequency the inverter outputs when
	EXT-06 ~ EXT-10: Analog Voltage Input (V2)						there is the maximum voltage (EXT-09) on the ‘V2’
	Signal Adjustment – Sub-A, Sub-C						terminal.

This is used to adjust the analog voltage input signal when				Reference Frequency
the frequency is referenced or overridden by the ‘V2’				EXT-10
control terminal. This function is applied when EXT-05 is
set to ‘Override’ or ‘Reference’. Reference Frequency
versus Analog Voltage Input Curve can be made by four
parameters of EXT-07 ~ EXT-10.
EXT► V2 filter		06	10	EXT-08		Analog Voltage
06	10 ms
Factory Default:	10 ms		10	EXT-07	EXT-09	Input (V2)
				[Reference Frequency vs. Analog Voltage Input, V2 (0 to 10V)]

6-54