HP 30 30 manual Sub-C Board Isolated, + F

Chapter 7 - Options

7.3 Sub-C Board (Isolated)

7.3.1Board Configuration

NFB	MC				U
3P		R					IM
					V
230/460 V		S
50/60 Hz					W
		T
		E			FM	+ F	Output freq *2
			24 V			M
					5G		analog meter
							(0-10V, 1mA)
		FX			VR
FWD Run/Stop					V2		Potentiometer
			Maximum
							1kohm, 1/2W
REV Run/Stop		RX	current thru	Sub- C	GND
			PC: 5mA			Analog meter output 1
Emergency brake		BX		Board	AM1
						(0-10V, 1mA)
	Fault reset	RST			AM2	Analog meter output 2
						(0-10V, 1mA)
		JOG
	JOG
Multi-function input 1		P1	Factory setting:	Multi-function	P4	XCEL-L
Multi-function input 2		P2	Multi-speed		P5	XCEL-M
			input	input
Multi-function input 3		P3	(Speed-L,M,H)		P6	XCEL-H
				Open collector
Common Terminal		CM			CM	Common terminal
				Multi-function		for P4-6
				input (Less than
				25V, 50mA)
				ÇÏ	Q1
						FDT-1
			Power supply for
		VR				Common terminal
Potentiometer			speed signal
			(+12V 10mA)		EXTG	for Q1
1kohm, 1/2W			Speed signal input
		V1		30A
			0- 10V(1 kohm)			Fault output relay
			Speed signal input	30C		Less than AC 250V, 1A
		I				Less than DC 30V, 1A
			4 - 20mA (250 ohm)	30B
		5G	Common	AXA		Multi-function output relay
			terminal for			Less than AC 250V, 1A
Speed signal input	*3		VR,V1, I	AXC		Less than DC 30V, 1A
						Factory setting:'Run'

Note) 1. : Main circuit : Control circuit

2.Output voltage is adjustable up to 12V

3.Three types of External speed signal input available.

(V, I, V+I, Refer to Parameter list and description for more details)

7-10