HP 30 30 manual Operation LCD Keypad Display, 00 Hz, Displays Description

Chapter 2 - Operation

2.2.1LCD Keypad Display

2) Run/Stop Source	3) Frequency Setting Source
1) Parameter group	4) Output Current

		DRV¢ºT/K	0.0 A
		00 STP	0.00 Hz
5) Parameter Code			7) Drive Output Frequency During Run,
	6) Operating Status		Command Frequency During Stop
Displays			Description
1) Parameter Group		Displays the parameter group. There are DRV, FU1, FU2, I/O, EXT, COM, APP groups.
2) Run/Stop Source		Displays the source of motor Run and Stop
		K: Run/Stop using FWD, REV buttons on keypad
		T: Run/Stop using control terminal input FX, RX
		O: Run/Stop via option board
3) Frequency Setting		Displays the source of command frequency setting
Source		K: Frequency setting using keypad
		V: Frequency setting using V1 (0 ~10V) or V1 + I terminal
		I: Frequency setting using I (4 ~ 20mA) terminal
		U: Up terminal input when Up/Down operation is selected
		D: Down terminal input when Up/Down operation is selected
		S: Stop status when Up/Down operation is selected
		O: Frequency setting via Option board
		X: Frequency setting via Sub board
		J: Jog terminal input
		1 ~ 8: Step frequency operation
		* During Auto operation, 2) and 3) display the ‘sequence number/step’.
4) Output Current		Displays the Output Current during operation.
5) Parameter Code		Displays the code of a group. Use the ▲(Up), ▼(Down) key to move through 0~99 codes.
6) Operating Status		Displays the operation information.
		STP: Stop Status
		FWD: During Forward operation
		REV: During Reverse operation
		DCB: During DC Braking
		LOP: Loss of Reference from Option Board (DPRAM fault)
		LOR: Loss of Reference from Option Board (Communication network fault)
		LOV: Loss of Analog Frequency Reference (V1: 0~10V)
		LOI: Loss of Analog Frequency Reference (I: 4~20mA)
		LOS: Loss of Reference from Sub-Board
7) Drive Output Frequency		Displays the Output Frequency during run.
Command Frequency		Displays the Command Frequency during stop.

2-3