HP 30 30 manual FUN1 Group, FUN2 Group, I/O Group

Chapter 2 - Operation

2.3.2Procedure for Setting Data (7-Segment Keypad)

In DRV Group:

1.Rotate the encoder knob until the desired parameter code is displayed.

2.Press [PROG/ENT] key to go into the programming mode, then the display blinks.

3.Press [SHIFT/ESC] key to move the cursor to the desired digit.

4.Rotate the encoder knob to change the data.

5.Press [PROG/ENT] key to enter the changed data.

In FUN1 Group:

1.Rotate the encoder knob until parameter code ‘20’ is displayed in drive group.

2.Press [PROG/ENT] key to go into the FUN1 group.

3.Rotate the encoder knob until the desired parameter code is displayed.

4.Press [PROG/ENT] key to go into the programming mode, then the display blinks.

5.Press [SHIFT/ESC] key to move the cursor to the desired digit.

6.Rotate the encoder knob to change the data.

7.Press [PROG/ENT] key to enter the changed data.

In FUN2 Group:

1.Rotate the encoder knob until parameter code ‘21’ is displayed in drive group.

2.Go to step 2 of ‘In FUN1 Group’ above, and follow the rest procedure.

In I/O Group:

1.Rotate the encoder knob until parameter code ‘22’ is displayed in drive group.

2.Go to step 2 of ‘In FUN1 Group’ above, and follow the rest procedure.

2-8