HP 30 30 manual DRV-01 Acceleration Time, Parameter Description DRV, Acc. time, 10.0 sec

Chapter 6 - Parameter Description [DRV]

Code	Keypad Display	Parameter Name
I/O-01	V1 filter	Filter Time Constant for
		V1 Signal Input
I/O-02	V1 volt x1	V1 Input
		Minimum Voltage
		Frequency
I/O-03	V1 freq y1	Corresponding to V1
		Input Minimum Voltage
I/O-04	V1 volt x2	V1 Input Maximum
		Voltage
		Frequency Corresponding
I/O-05	V1 freq y2	to V1 Input Maximum
		Voltage

➨Important : Increase I/O-01-[Filter Time Constant for V1 Signal Input] if the V1 signal is affected by noise causing unstable operation. Increasing this value makes response time slower.

Set freq.

I/O-05

I/O-03

V1 analog input (0~10V)

I/O-02	I/O-04
V1 Minimum V	V1 Maximum V

I/O-06~10 [ Analog Current Input “ I “ Signal adjustment ]

Command Freq/Torque setting via “I” input terminal when set DRV-04 [Frequency/Torque mode] to 3 (I) or 4 (V1+I)

Code	Default setting	Setting range
I/O-06	10 [msec]	0 ~ 10000 [msec]
I/O-07	4 [mA]	0 ~ 20 [mA]
I/O-08	0 [Hz]	0 ~ Max. freq
I/O-09	20 [mA]	0 ~ 20 [mA]
I/O-10	60 [Hz]	0 ~ Max. freq

Code	Keypad display	Parameter Name
I/O-06	I filter	Filter time constant for I signal
		Input
I/O-07	I curr x1	I Input Minimum Current
I/O-08	I freq y1	Frequency Corresponding to I
		Input Minimum Current
I/O-09	I curr x2	I Input Maximum Current
I/O-10	I freq y2	Frequency Corresponding to I
		Input Maximum Current

➨Important : Increase I/O-06-[Filter time constant for I signal Input] if the I signal is affected by noise causing unstable operation. Increasing this value makes response time slower.

Set freq

I/O-10

I/O-08

Terminal I ( 0 ~ 20 mA )

I/O-07	I/O-09
I Minimum	I Maximum
current	current

Related parameters : DRV-04 [Frequency or Torque Mode] DRV-16 [Speed Unit Selection] FU1-20 [Maximum Frequency] FU2-39 [Control Mode Selection] I/O-1~10 [Analog Frequency command/Torque]

DRV-01: Acceleration Time

DRV►	Acc. time		01	10.0
01	10.0 sec
Factory Default:		10.0 sec		10.0

6-2