HP 30 30 manual FU2-21 Restart After Fault Reset, 0000, RST restart, FU2Speed Search

Chapter 6 - Parameter Description [FU2]

Input Power Power On

Time Output Frequency

			Time
	No Effect	Start
FX-CM	ON	ON	Time

Input Power Power On

Time Output Frequency

[Power ON Start: ‘No’]

		Time
	Start
FX-CM	ON	Time

[Power ON Start: ‘Yes’]

☞Note: In case of using ‘Power ON Start’ to ‘Yes’, make sure to utilize appropriate warning notices to minimize the potential for injury or equipment damage.

Related Functions: FU2-22 ~ FU2-25 [Speed Search]

FU2-21: Restart After Fault Reset

FU2►	RST restart		21	0
21	--- No ---
Factory Default:		No		0

If FU2-21 is set to ‘Yes’, inverter will restart after the RST (reset) terminal has been reset a fault.

If FU2-21 is set to ‘No’, restart the inverter by cycling the FX or RX terminal to CM terminal after the fault has been

reset. If the motor is rotating by inertia at the time power is restored, the inverter may trip. To avoid this trip, use ‘Speed Search’ function by setting FU2-22 to ‘xx1x’.

Output Frequency Tripped

			Time
	No Effect	Start
FX-CM	ON	ON	Time
RST-CM	ON		Time

	[Reset restart: ‘No’]
Output Frequency	Tripped

		Time
	Start
FX-CM	ON	Time
RST-CM	ON	Time

[Reset restart: ‘Yes’]

☞Note: In case of using ‘Reset Restart’ to ‘Yes’, make sure to utilize appropriate warning notices to minimize the potential for injury or equipment damage.

Related Functions: FU2-22 ~ FU2-25 [Speed Search]

FU2-22: Speed Search Selection (Bit Set)

FU2-23: Current Limit Level During Speed Search

FU2-24: P Gain During Speed Search

FU2-25: I Gain During Speed Search

FU2►Speed Search		22	0000
22	0000
Factory Default:	0000		0000

6-18