HP 30 30 manual Appendix a Functions Based on USE, Use Related Parameter Code

APPENDIX A - FUNCTIONS BASED ON USE

Set the function properly according to the load and operating conditions. Application and related functions are listed in the following table.

Use		Related Parameter Code
Accel/Decel Time, Pattern Adjustment		DRV-01 [Acceleration Time], DRV-02 [Deceleration Time],
		FU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]
Reverse Rotation Prevention		FU1-03 [Forward, Reverse Prevention]
Minimum Accel/Decel Time		FU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]
Accel/Decel at Continuous Rating Range		FU1-05 [Acceleration Pattern], FU1-06 [Deceleration Pattern]
Braking Operation Adjustment		FU1-07 [Stop Method], FU1-08~11 [DC Braking],
		FU1-12~13 [DC braking at start]
		FU1-20 [Maximum Frequency],
Operations for Frequencies Over 60 Hz		FU1-25 [Frequency Upper Limit],
		I/O-05 [Frequency Corresponding to Max. Voltage of V1],
		I/O-10 [Frequency Corresponding to Max. Current of I]
Selecting an Appropriate Output		FU1-20 [Maximum Frequency],
Characteristics for the Load		FU1-21 [Base Frequency]
		FU1-22 [Starting Frequency],
Motor Output Torque Adjustment		FU1-26~28 [Torque Boost],
		FU1-59~60 [Stall Prevention],
		FU2-30 [Rated Motor]
Output Frequency Limit		FU1-23~25 [Frequency Upper/Lower Limit],
		I/O-01~10 [Analog Frequency Setting]
Motor Overheat Protection	FU1-50~53 [Electronic Thermal], FU2-30 [Rated Motor]
		I/O-12~14 [Define the Multi Function Input Terminals],
Multi Step Operation		I/O-20~27 [Jog, Multi Step Frequency],
		FU1-23~25 [Frequency Upper/Lower Limit]
Jog Operation		I/O-20 [Jog Frequency]
Frequency Jump Operation	FU2-10~16 [Frequency Jump]
Timing the Electronic Brake Operation		I/O-42~43 [Frequency Detection Level],
		I/O-44 [Multi Function Output]
Displaying the Rotating Speed		DRV-04 [Motor Speed],
		FU2-74 [Motor RPM Display Gain]
Function Alteration Prevention		FU2-94 [Parameter Lock]
Energy Saving		FU1-39 [Energy Saving]
Auto Restart Operation After Alarm Stop		FU2-27~28 [Auto Retry]
2nd Motor Operation		FU2-81~90 [2nd Function]
PID Feedback Operation	FU2-50~54 [PID Operation]
Frequency Reference Signal and Output		I/O-01~10 [Analog Frequency Setting]
Adjusting
Define the Multi-Function Input Terminals		I/O-12~14 [Define the Multi-Function Input Terminals]
Define the Multi-Function Input Terminals	I/O-44 [Multi Function Auxiliary Contact Output Setting]
Commercial Line ⇔ inverter Switchover		I/O-12~14 [Define the Multi-Function Input Terminals],
Operation		I/O-44 [Multi-Function Auxiliary Contact Output Setting]
Frequency Meter Calibration		I/O-40~41 [FM Output]
		I/O-46 [Inverter No.],
Operate by Communicating with a Computer		I/O-47 [communication Speed],
		I/O-48~49 [Loss of Reference]
		i