Chapter 3 - Quick-Start Procedures

3.2 Operation using Control Terminals

1.Install a potentiometer on terminals V1, VR, 5G and connect wiring as shown below.

 

1 , 1/2 W

P1 P2 P3 FX RX NC VR VI

JOG CM CM BX RST I

FM 5G

2.Apply AC power.

3.Confirm that the DRV 03 is set at ‘Fx/Rx-1’.

4.LCD: Press [▲] key to move DRV 04.

7-Seg:Rotate encoder knob until ‘04’ is displayed.

5.LCD: Press [PROG] key.

7-Seg: Press [PROG/ENT] key.

6.LCD: Press [▲] key and set at ‘V1’.

7-Seg:Rotate encoder knob and set at ‘2’.

LCD Display

DRV►T/K

0.0 A

00 STP

0.00Hz

 

 

DRV► Drive mode

03 Fx/Rx-1

DRV► Freq mode

04 Keypad-1

DRV► Freq mode

04 Keypad-1

DRV► Freq mode

04 V1

7-Segment Display

The DRV LED is ON.

The PROG/ENT LED is turned ON.

The PROG/ENT LED is turned ON.

7.LCD: Press [ENT] key.

7-Seg: Press [PROG/ENT] key.

8.Press [SHIFT/ESC] key.

9.Set the frequency by rotating the potentiometer.

DRV► Freq mode

04 V1

DRV►T/V

0.0

A

00

STP

0.00Hz

 

 

 

 

 

 

DRV►T/V

0.0

A

00

STP

60.00Hz

The PROG/ENT LED is turned OFF.

10.Close the FX or RX contact to run the motor.

11.Open the FX or RX contact to stop the motor.

The FWD or REV LED starts blinking.

The STOP/RESET LED starts blinking.

The RUN LED starts blinking.

The STOP/RESET LED starts blinking.

3-3

Page 43
Image 43
HP 30 30 manual Operation using Control Terminals, LCD Display, 2 W