HP 30 30 manual Protection & fault detection level setting

Chapter 4 – Function Settings

5) Parameter initialize

	Parameter Name	Code	Description
	Software version	FU2-79	Display the inverter software version
	Parameter	FU2-91	[FU2-91], [FU2-92]: Copying parameters from other
		FU2-92	inverter enabled
	Read/Write/Initialize/Write
		FU2-93	[FU2-93]: Initializing parameters to factory setting values
	protection
		FU2-94	[FU2-94] : Parameter write disabled
6) Protection & fault detection level setting
	Parameter Name	Code	Description
		FU1-50	Protection of the motor from overheating without the use of
		FU1-51
	Electronic thermal		external thermal relay. Refer to parameter descriptions for
		FU1-52
			more detail.
		FU1-53
	Overload alarm and trip	FU1-54, FU1-55	Warning alarm outputs and displays the trip message when
		FU1-56, FU1-57
			overcurrent above the threshold value keeps on.
		FU1-58
			Set the output current level at which the output freq will be
	Stall prevention	FU1-59, FU1-60	adjusted to prevent the motor from stoping due to over-
			current etc. it activates during accel/ constant speed/ decel
			to prevent the motor stall.
7) Starting / Accel/ Decel / Stopping pattern setting
	Parameter Name	Code	Description
			5 types of Accel/ Decel pattern: ‘Linear’, ‘S-curve’, ’U-
	Accel/Decel pattern	FU1-05	curve’, ’Minimum’, ‘Optimum’ settable according to
		FU1-06	appplication and load characteristic. If ‘S-curve’ is selected,
			the desired value of [FU2-17], [FU2-18] is settable.
	Stopping method	FU1-07	3 types of stopping method ‘Decel’, ‘DC-brake’, ‘Free-run’
			selectable. If ‘DC-brake’ is selected, the desired value of
			[FU1-8]~ [FU1-11] is settable.
			The motor accelerates after the preset [FU1-12] for the
	Starting DC Injection	FU1-12	preset [FU1-13] is applied. Starting DC injection braking is
	Braking Voltage/ Time	FU1-13	inactive when the value is set to 0 in control mode other
			than V/F and Slip compensation.
			Limits the active frequency. Inverter operates at the freq
	Frequency Limit selection	FU1-23	range between upper freq limit [FU1-25] and bottom freq
		Fu1-24	limit [FU1-24] and higher/ lower freq value is entered, it is
		FU1-25	automatically replaced by limit value. Setting range: [FU1-
			20] Maximum freq to [FU1-21] Base freq.
	Dynamic braking	FU2-75	Select the DB resistor mode when the regenerative load. Is
		FU2-76	connected. Refer to DBU manual for more details.

4-6