JVC VR-509E Making Normal Recordings, Making Normal Recording with the EXT REC I/O Terminals

Making Normal Recordings

STANDARD MODE

1.Set up the DETAIL REC parameters. (See page 30)

2.Set the normal recording parameters with [STANDARD MODE]. (See page 31)

3.Check to confirm that the LED for TIMER/MODE is extinguished.

„Press the [REC/STOP] button.

•Recording will be started.

„Press the [REC] button for approximately two consecutive seconds.

•Recording will be stopped.

REC PATTERN 1 to 9

1.Set up the DETAIL REC parameters. (See page 30) The desired REC PATTERN mode can be set with the [TIMER/MODE (REC PATTERN)] setting on the [DETAIL REC] screen (select from REC PATTERN 1 to 9.)

2.Set the normal recording parameters with [REC PATTERN 1 to 9]. (See page 31)

3.Press [TIMER/MODE].

• The TIMER/MODE LED will be illuminated.

„Press the [REC/STOP] button.

•Recording will be started in accordance with each normal mode setting.

„Press the [REC] button for approximately two consecutive seconds.

•Recording will be stopped.

MEMO

•The contents from the start to the end of recording are saved on the hard disk as a single event.

•The [REC] indicator on the front panel will be illuminated during recording if the [REC INDICATOR] setting on the [OPERATION] screen is set at [ON].

•It is possible to set the operations that are to be performed when the hard disk runs out of space with the [REPEAT REC] setting on the [OPERATION] screen. When the [REPEAT REC] setting is set at [ALARM LOCK] or [ALL], recordings will be written over the oldest recordings to enable operations to continue. (See “Operation Setup” on page 32)

Recording Camera Images

Making Normal Recording with the EXT REC I/O Terminals

Enables the start and stop operations when recording to be controlled by signals input to the [EXT REC IN] terminal on the rear panel, instead of the [REC/STOP] button.

1.Set the [EXT REC IN] setting to [TRIGGER] or [MANUAL]. (See page 49)

„When the [EXT REC IN] is set at [TRIGGER]

•Normal recording is started when the [EXT REC IN] terminal is set to [MAKE].

•Press the [REC/STOP] button for approximately two consecutive seconds to stop recording.

„When the [EXT REC IN] is set at [MANUAL]

•Normal recording is started when the [EXT REC IN] terminal is set to [MAKE].

•Recording is stopped when the [EXT REC IN] terminal is set to [OPEN].

Recording Status Notification

The status of the recording can be examined during recording with the use of the LED lamps and the signals output from the [REC OUT] terminal.

•Setting the operations for the recordings LEDs. (See page 32)

•Setting the [REC OUT] terminal. (See page 49)

29