JVC VR-509E Turning On/Off the Power, Switching the Power On, Switching the Power Off

Installation and Preparation

Turning On/Off the Power

Switching the Power On

1.Connect the Power Cable.

•Connect using the power cable supplied to an AC 220 V - 240 V 50Hz/60Hz outlet.

2.Switch on the power switch on the rear panel.

•The main power is turned on to initiate a system check.

•The OPERATE LED will blink.

•The OPERATE LED will then be steadily illuminated, indicating that the OPERATE ON mode has been activated. Operations are possible when the REC/STOP mark appears on the on-screen menu.

CAUTION

Do not disconnect the power cable when the system check is being run under any circumstances. Failure to observe this may result in malfunctions.

Switching the Power Off

1.Press the [OPERATE] button for at least two consecutive seconds to move across to the OPERATE OFF mode.

• The OPERATE LED will be extinguished.

2.Switch off the power switch on the rear panel.

MEMO

It is recommended that a UPS (Uninterruptible Power Supply) is used in consideration of power failures, etc. (See System Connection on page 15)

(See Connecting a UPS on page 64)

Switching between OPERATE ON/OFF with the button on the front panel

It is possible to switch between the operational mode (OPERATE ON) and the stand-by mode (OPERATE OFF).

OPERATE ON

„Press the [OPERATE] (when in the OPERATE OFF mode.) button.

•The OPERATE LED will blink.

•The OPERATE LED will then be steadily illuminated, indicating that the OPERATE ON mode has been activated. Operations are possible when the date and time appears on the on-screen menu.

*The OPERATE ON mode will be started up automatically when the power switch on the rear panel is switched on.

OPERATE OFF

„Press the [OPERATE] button for at least two seconds (when in the OPERATE ON mode.)

•The OPERATE LED will blink.

•A message stating “Please wait...” will be displayed.

•The OPERATE OFF mode will then be activated, and the OPERATE LED will be extinguished.

*Activate the OPERATE OFF mode before switching off the power.

Switching between OPERATE ON/OFF with the signal I/O terminal

OPERATE ON

„Set the OPERATE ON/OFF terminal to Low (0V) (when in the OPERATE OFF mode.)

•A system check will be started.

•The OPERATE ON mode will then be activated. Operations are possible when the date and time appear on the on-screen menu.

OPERATE OFF

„Set the OPERATE ON/OFF terminal to Low (0V) (when in the OPERATE ON mode.)

•A message stating “Please wait...” will be displayed.

•The OPERATE OFF mode will then be activated, and the OPERATE LED will be extinguished.

*Activate the OPERATE OFF mode before switching off the power.

16