85
Changing VR-509 Settings Using a PC
1. Click on “FUNCTION” → “MOVEMENT SETUP” in that
order.
2. Change the settings. (See page 32 for details)
3. Click on the [SAVE] button.
(Click on the [RESET] button to return to the setting values
on the main unit.)
1. Click on “FUNCTION” → “AUDIO OUT” in that order.
2. Change the settings. (See page 45 for details)
3. Click on the [SAVE] button.
(Click on the [RESET] button to return to the setting values
on the main unit.)
1. Click on “FUNCTION” → “ALARM TERMINAL” in that
order.
2. Change the settings.
• A table with the alarm input terminals laid out vertically
and the camera inputs laid out horizontally will be
displayed.
• If a check mark is added to the number that denotes the
camera input to the right of a alarm terminal that has
received an input, it means it has been enabled. If it
remains blank, it means it is disabled.
3. Click on the [SAVE] button.
(Click on the [RESET] button to return to the setting values
on the main unit.)
* When the display is grayed out, it indicates that the
camera input settings for the [INTRODUCTION SET-1]
that correspond to the grayed out cameras have been set
to [DISCONNECT]. (See page 20)
1. Click on “FUNCTION” → “REAR TERMINAL” in that
order.
2. Change the settings. (See page 49 for details)
3. Click on the [SAVE] button.
(Click on the [RESET] button to return to the setting values
on the main unit.)
1. Click on “FUNCTION” → “BUZZER” in that order.
2. Change the settings. (See page 49 for details)
3. Click on the [SAVE] button.
(Click on the [RESET] button to return to the setting values
on the main unit.)
OPERATIONAUDIO OUTALARM TERMINAL
2.
3.
2.
3.
2.
3.
REAR TERMINALBUZZER
2.
3.
2.
3.