HELIX DN9340E/DN9344E Remote Control Software
User Guide
2To apply autogain, tick the AutoGain check box and type in (or scroll) the required value in the field below.
3Use the Unit Display drop down menu to set the Graphic display mode that DN9340 units should assume when taken out of slave operation; this only comes into effect if the slave is a DN9430. The choice made here has no effect on your AddIn device display.
To Bypass the graphic EQ on the current channel
Tick the Bypass check box in the upper tab.
To adjust a fader level
Hint To help fader selection at the graph, the frequency band and dB level is displayed as you hover over a fader.
Click and drag the fader on the graph or on the lower tab. The graph and tab faders are linked so that they move simultaneously.
The overall frequency response (black line) updates as you adjust the fader. The individual response of the fader is also shown (in red) while the fader is selected.
To adjust a group of faders together
1Click and drag the cursor diagonally over the group of faders to enclose them in the selection box. The selected faders are highlighted in red.
2Click and drag any of the selected faders to move the whole group up or down by the same dB while retaining their relative values.
3To deselect the group, click anywhere on the graph outside the group.
The overall frequency response (black) updates as you adjust the group. The individual response (red) is only shown for the fader that you drag. If required, the response of the other faders can be checked by clicking on each one in turn.
To reset all faders to zero
Click on the
All Flat
button in the Global Graphic tab.
To switch a fader out of the circuit
1Tick the check box directly beneath the fader in the lower tab.
The fader response is faded to grey on the graph (the setting is retained for recall) and its contribution is removed from the overall frequency response.
2To switch the fader in again, clear the check box.
Fader In
Fader Out
15 of 65
