Klark Teknik DN9340E, DN9344E manual To switch to the Dynamic Equalisation view, User Guide

HELIX DN9340E/DN9344E Remote Control Software

User Guide

5.3Dynamic Equalisation

To switch to the Dynamic Equalisation view

Click on the

Dynamic

button of the Channel A or B Navigation Strip, as required. (If staying

on the same Channel you may prefer to click on a Dynamic tab).

The black graph shows overall response. The red graph shows the response of the selected LO or HI Dynamic

Tick the check box to switch the

PEQ section out of the circuit

Dynamic Mode tab

The Dynamic section’s freq, level and Q are adjusted by dragging the ‘target’ or setting values

For a shelf dynamic, choose an EQ slope

The upper Dynamic Mode tab is used to set the characteristic of the Threshold Dependent Dynamic EQ ( T-DEQ), bypass state and graph display mode (when a DN9340) for the current channel. The lower Dynamic Shaping tab provides a control panel for each of the two Dynamic EQ sections that can be applied to the frequency response. The Dynamic EQ sections can also be adjusted at the display by using the target cursor.

To set the Dynamic EQ mode for the channel

1Select a Proportional, Constant or Symmetrical Q

characteristic from the EQ Type drop down menu.

2Use the Unit Display drop down menu to set the Dynamic EQ display mode that DN9340 units should assume when taken out of slave operation; this only comes into effect if the slave is a DN9430. The choice made here has no effect on your AddIn device display.

Note Refer to the DN9340/DN9344 Operators Manual for application notes on Equalisation modes and Q.

18 of 65