HELIX DN9340E/DN9344E Remote Control Software

User Guide

7.7Solo Tracking Operation

If required, the Solo Tracking system of the Midas mixing console in use can be set up to select the slave equalisers in the Helix Network. To enable this, the various Solo Tracking buttons must be assigned to Helix channels via the System Solo Tracking Setup screen (shown below) and the settings downloaded to a DN9340 Helix unit that is currently connected to the console Solo Tracking output (the DN9344 does not have a Solo Tracking input).

To open the System Solo Tracking Setup screen

Switch to the FastNav® screen and choose Solo Tracking .

This field defaults to the

Master Unit set in the

Function Lockout screen

List of console Solos buttons assigned to the EQ channels

Name changes will be copied to Device screens

Solo selections change to match Console Type

Clear all the current assignments

The screen contains a scrollable list similar to the Solo Tracking System Configuration page of the DN9340E Helix unit, showing the 32 HELIX equaliser channels and their currently assigned solos. Assignments are made via the fields in the Solo Tracking Setup panel at the right-hand side. The available Solo Source and Num settings change to match the chosen Console Type.

To assign solo sources to HELIX channels

1Specify the console to be used for the performance in the Console Type field in the top right-hand corner of the screen. Any current assignments that are not valid for the chosen console are flagged as invalid by an asterisk in the right-hand column.

2Highlight the HELIX channel in the list and choose the required Solo Source from the drop down list on the right-hand panel and then choose a number from the Num drop down list. (The Num list changes to suit the selected Solo Source).

46 of 65

Page 46
Image 46
Klark Teknik DN9340E, DN9344E manual Solo Tracking Operation, To open the System Solo Tracking Setup screen