Lexmark 41G0100, 41H0000, 41G0050, C748x, C746x manual Installing a flash memory or firmware card

Additional printer setup 20

5Push the memory card straight into the connector until it clicks into place, and then push the latches to firmly attach the card into the connector.

1

6Reattach the system board cover.

2

2

Installing a flash memory or firmware card

The system board has two connections for an optional flash memory or firmware card. Only one of each may be installed, but the connectors are interchangeable.

CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the wall outlet before continuing. If you have other devices attached to the printer, then turn them off as well, and unplug any cables going into the printer.

Warning—Potential Damage: System board electronic components are easily damaged by static electricity. Touch something metal on the printer before touching any system board electronic components or connectors.

Note: This task requires a flathead screwdriver.

1Access the system board.

For more information, see“Accessing the system board” on page 16.

2Unpack the card.

Warning—Potential Damage: Avoid touching the connection points along the edge of the card.

3Holding the card by its sides, align the plastic pins (1) on the card with the holes (2) on the system board.

12