
Attendance messages
Message | Meaning | Action |
Change [src] to [size] | Lets the user override the current | Touch Use current [src] to ignore the message |
[type] | print media source for the remainder | and print on the print media loaded in the tray. |
| of the print job. The formatted page | Touch Continue: |
| prints as is on the print media | |
| • which continues the job if the correct size and | |
| installed in the tray. This may cause | |
| clipping of text or images. | type are loaded in the tray, and this size and |
|
| type are specified in the Paper Menu using |
|
| the LCD. |
|
| • which is ignored if there is no print media in |
|
| the tray. |
|
| Touch Cancel Job to cancel the current job if |
|
| needed. |
|
|
|
Check duplex connection | All trays installed under the duplex | Touch Continue to reconfigure the MFP. It |
| unit are unavailable if communication | resumes printing without the duplex unit and |
| is lost, which only leaves Tray 1. | assumes the unit is unplugged or has lost |
| If the duplex unit is removed and all | communication. |
|
| |
| trays are reattached, then all the trays |
|
| are available. The message clears |
|
| once communication is re- |
|
| established. |
|
|
|
|
Check tray [x] | Tray [x] is not fully connected to the | If the cause is a hardware failure, turn the MFP |
connection | MFP or it has a hardware failure. x | off, wait 10 seconds, and then turn the MFP on. |
| represents the number of the tray. | If the error recurs, turn the MFP off and remove |
| The message clears once | the offending tray. |
| communication is | Touch Continue to reconfigure the MFP to not |
|
| |
|
| have tray [x]. Tray [x] and all trays installed |
|
| below it are ignored. |
|
|
|
Clean scanner backing | During a scanner calibration, the | Touch Cancel Job if a scan job is processing |
strip | firmware detects that the scanner | when the attendance message appears. This |
| backing strip for the backside of scan | cancels the job and clears the message. |
| jobs may be dirty. | Touch Scan from Automatic Document Feeder |
|
| |
|
| if the page jam recovery is active. Scanning |
|
| resumes from the ADF immediately after the |
|
| last successfully scanned page. |
|
| Touch Scan from flatbed if page jam recovery is |
|
| active. Scanning resumes from the flatbed |
|
| immediately after the last successfully scanned |
|
| page. |
|
| Touch Finish job without further scanning if |
|
| page jam recovery is active. The job ends at the |
|
| last successfully scanned page, but the job is |
|
| not canceled. Successfully scanned pages go |
|
| to their destination: copy, fax, |
|
| Touch Restart job if job recovery is active and |
|
| the job is restartable. The message clears. A |
|
| new scan job containing the same parameters |
|
| as the previous job starts. |
|
|
|
97