Lexmark 912 Using printer menus, Setup Menu, Menu Item, Purpose, Values, Page Protect, Print Area

Using printer menus

Menu Item	Purpose	Values
Page Protect	To successfully print a page that	Off*	Prints a partial page of data if
	may otherwise generate Complex		memory is insufficient to process
	Page errors.		the entire page.
	If, after selecting On, you still
		On	Ensures that an entire page is
	cannot print the page, you may		processed before it prints.
	also have to reduce the size and
	number of fonts on the page, or
	increase the installed printer
	memory.
	For most print jobs, you do not
	need to select On. When On is
	selected, printing may be slower.
Power Saver	To specify the amount of time (in	Disabled	This value does not appear unless
	minutes) the printer waits after a		Energy Conserve is set to Off.
	job is printed before it goes into a
		1...240	Specifies the amount of time after
	reduced power state.
			a print job before the printer goes
			into Power Saver mode. (Your
			printer may not support the entire
			range of values.)
			The factory default Power Saver
			setting depends on your printer
			model. Print the menu settings
			page to determine the current
			Power Saver setting. When the
			printer is in Power Saver mode, it
			is still ready to receive print jobs.
			Select 1 to put the printer in Power
			Saver mode one minute after it
			finishes a print job. This uses
			much less energy, but requires
			more warm-up time for the printer.
			Select 1 if your printer shares an
			electrical circuit with room lighting
			and you notice lights flickering.
			Select a high value if your printer is
			in constant use. Under most
			circumstances, this keeps the
			printer ready to print with minimum
			warm-up time. Select a value
			between 1 and 240 minutes if you
			want a balance between energy
			consumption and a shorter warm-
			up period.
Print Area	To modify the logical and physical	Normal*	Note: The Whole Page setting
	printable area.		only affects pages printed using
		Fit to Page
			PCL 5 interpreter. This setting has
		Whole Page	no effect on pages printed using
			the PCL XL or PostScript
			interpreters. If you try to print any
			data in the non-printable area
			defined by Normal Print Area, the
			printer clips the image at the
			boundary defined by the Normal
			defined printable area.

Setup Menu

85