Muratec MFX-2830 manual Reception Errors

In This

Case...

T: Transmission Errors

Mode	Error code	Description
Transmission	T.5.1,	The line cut off during document trans-
	T.5.2, T.5.3	mission (due to a line error)
	T.8.10,	Due to a line error, communication failed
	T.8.11
ECM
	T.8.1	The reception mode does not match

Countermeasure

▲Resend the document. If this error occurs repeatedly, contact your Muratec dealer.

▲Check the receiving machine. It sometimes turns out that the receiving party is not using a fax machine.

R: Reception Errors

Mode

G3 Reception

ECM Reception

Error code	Description
	Your machine is set to manual reception or
R.1.1	transfer reception and is ready to receive,
	but no signal comes from the sending party
	Your machine’s mode does not match
	with the sending party’s
R.1.2	Received Junk fax when the junk fax
	block function is on (only the auto print
	journal is displayed)
R.1.4	Pressed STOP during reception (Only the
	auto print journal is displayed)
R.1.5	Due to a line error, communication failed
R.2.3	Due to a line error, the line cut off
R.3.1	Pulled out the document or the Stop key
	was pressed by the sending party
R.3.3	Due to a line error, the signal cut off (due
	to line error)
	Due to a line error, reception is not avail-
R.3.4	able even at the slowest speed (due to
	line error)
R.3.5	Due to a memory overflow, the reception
	failed
R.4.2	Due to a line error, the signal cut off dur-
	ing reception (due to line error)
R.4.4	Memory overflow (only the auto print
	journal is disaplayed)
R.5.1	The signal cut off during reception
	The sending party pressed STOP
R.5.2	Due to a line error, the signal cut off dur-
	ing reception (due to line error)
R.8.10,	Due to a line error, communication failed
R.8.11
R.8.1	Your machine’s mode does not match
	with the sending party’s

Countermeasure

▲The sending party may have made an operational mistake. If you know whom the sending party is, ask them to resend the document.

▲If you know whom the sending party is, ask them to resend the document. If this error occurs repeatedly, contact your Muratec dealer.

▲If you know whom the sending party is, ask them to resend the document.

▲If you know whom the sending party is, ask them to resend the document. If this error occurs repeatedly, contact your Muratec dealer.

▲Check the amount of memory left and ask the send- ing party to send the document again.

▲If you know whom the sending party is, ask them to resend the document. If this error occurs repeatedly, contact your Muratec dealer.

▲If you know whom the sending party is, ask them to resend the document. If this error occurs repeatedly, contact your Muratec dealer.

▲Check the sending party’s machine. For example, their machine may not have the document in case of polling operation.

5-26In This Case... ● Maintenance and Troubleshooting