Muratec MFX-2830 manual Fax-Related

Error Message

■ Fax-Related

Error message	Countermeasure	Reference page
ADF used in feeder command	One or more of the following operations was attempted either dur-	3-28
	ing real-time transmission or when real-time transmission was
	reserved.
	· Press STOP.
	· Transmission to a different destination was instructed.
	· To store a document reserved for polling was instructed.
	Wait for the real-time transmission to finish, or cancel the reser-
	vation for real-time transmission before operating the unit.
Already stored	The same number has already been entered. Check the number
	and re-enter it.
Cannot select mode during Fax &	Attempting to change to the fax screen during Fax & Copy. Change	3-128
Copy	to the fax screen after Fax & Copy finishes.
Cannot store in security box	The box selected for F-Code document storage or deletion is a se-	3-120, 3-124
	curity box. Select a bulletin box.
Cannot use numeric keypad	Attempting to enter a direct dial number for a location using the	3-109
	F-Code box relay box. Enter the location using the one-touch key,
	the speed-dial, or a group number. The numeric keypad cannot be
	used.
Command is full	The number of reserved command has exceeded 100. Up to 100 re-
	served commands can be registered.
	Wait until the current reserved operations are completed before	3-5
	attempting the operation. Or, use real-time transmission.
Communication error	A communication error occurred. Check the contents of the com-	5-24
	munication error and repeat the operation.
	Press STOP if the “Communication error” does not disappear.
Document full	Registered 40 or more documents in the box designated for batch	3-70
	transmission. Print out the batch transmission document list.	3-71
	Check the registered documents to make the number of documents
	less than 39 by deletion.
Document stored	A polling reservation has already been stored. Normally, only one	3-92
	polling reservation can be stored.
	Batch transmission has been stored. When a batch transmission	3-68
	has been stored, the batch transmission box cannot be deleted.
Enter sub-address	No sub-address has been entered in the F-Code box. Enter the sub-	3-98
	address.
Incorrect passcode	Entered an incorrect passcode. Enter the correct passcode.	4-36
Input ratio (100-400%)	A ratio less than 100% was specified for enlarge transmission ra-	3-132
	tio. A reduction ratio cannot be specified, so reset the number to
	larger than 100%.
Invalid I.D. code	This message is displayed when you entered an incorrect I.D. code	3-102
	in printing the document stored in F-code Box. Enter the correct
	I.D. code.

Getting Started

COPY

Chapter1

COPY

Chapter2

COPY

Chapter3

FAX

Chapter1

FAX

Chapter2

FAX

Chapter3

FAX

Chapter4

Common Settings

In This

Case...

Appendix

In This Case... ● Maintenance and Troubleshooting 5-29