NEC 2000 Series manual Diskette Drive Problems, System shuts off instead of going into sleep mode

Models: 2000 Series

1 127
Download 127 pages 54.26 Kb
Page 86
Image 86

System shuts off instead of going into sleep mode.

You pressed and held in the power/sleep button for more than four seconds. For sleep mode, press in the button and immediately release.

System does not shut off after pressing the power/sleep button.

You might not have pressed and held in the power/sleep button long enough. Press in the button and hold for four seconds or more before

Treleasing.

System password forgotten.

Clear the password and reset it. To clear the password, see “System Board Jumper Settings” in Chapter 3. To reset the password, see “Security Menu” in Chapter 3.

Diskette Drive Problems

Check the following problems to see the possible cause and solution.

Diskette won’t load.

Check that a diskette is not in the drive.

Check that the diskette is being loaded correctly.

Check that the system power lamp is on and that the power-on screen appears.

Check that the diskette is formatted. If not, format it. See your operating system documentation.

Check that the diskette size is 1.44 MB.

If the diskette drive busy lamp does not light when you load the diskette, try a different diskette. If this loads, the problem is in the

Tsoftware.

Non-System Disk or Disk Error message displayed.

If you are trying to boot from the diskette drive, insert a diskette with system files into drive A.

If a bootable diskette does not boot, use the BIOS Setup Utility to verify that the initial boot parameter is set to diskette drive A and not a hard drive.

5-4 Solving System Problems

Page 86
Image 86
NEC 2000 Series manual Diskette Drive Problems, System shuts off instead of going into sleep mode