GS108T Smart Switch Software Administration Manual

Figure C-3

Note: Flat “silver satin” telephone cable might have the same RJ-45 plug. However, using telephone cable results in excessive collisions, causing the attached port to be partitioned or disconnected from the network.

Using 1000BASE-T Gigabit Ethernet over Category 5 Cable

When you use the new 1000BASE-T standard, you must consider the limitations of cable installations and the steps necessary to ensure optimum performance. The most important components in your cabling system are patch panel connections, twists of the pairs at connector transition points, the jacket around the twisted-pair cable, bundling of multiple pairs on horizontal runs, and punch down blocks. All of these factors affect the performance of 1000BASE-T technology if not correctly implemented. The following sections are designed to act as a guide to correct cabling for 1000BASE-T.

Cabling

The 1000BASE-T product is designed to operate over Category 5 cabling. To further enhance operation, the cabling standards have been amended. The latest standard is Category 5e, which defines a higher level of link performance than is available with Category 5 cable.

C-4

Network Cabling

v1.0, December 2007

Page 132
Image 132
NETGEAR GS108T-100NAS manual Using 1000BASE-T Gigabit Ethernet over Category 5 Cable, Cabling